The Vector Register block supports vector type inputs.
Description
The Vector Register block models a D flip-flop-based register, having latency of one sample period.
Block Interface
The block has one input port for the data and an optional input reset port. The initial output value is specified by you in the block parameters dialog box (below). Data presented at the input will appear at the output after one sample period. Upon reset, the register assumes the initial value specified in the parameters dialog box.
The Vector Register block differs from the Xilinx Delay block by providing an optional reset port and a user specifiable initial value.
Block Parameters
Open the Block Parameters dialog box by double-clicking the icon in your Simulink® model.
- Basic Tab
-
Parameters specific to the Basic tab are as follows.
- Initial value
- Specifies the initial value in the register.
- Optional Ports
-
- Provide synchronous reset port.
- Provide enable port.
- Super Sample Rate (SSR)
- This configurable GUI parameter is primarily used to control processing of multiple data samples on every sample period. This block enables 1-D vector support for the primary block operation.
Other parameters used by this block are explained in the topic Common Options in Block Parameter Dialog Boxes.
Xilinx LogiCORE
The Vector Register block is implemented as a synthesizable VHDL module. It does not use a Xilinx LogiCORE™ ™.