With the breakpoint established, you can link GDB to the
MATLAB®
process by using the GDB attach command, and
specifying the process ID (PID) returned by the
xmcImportFunctionSettings command when you set up the debug build mode, as
previously discussed. Use the following
command:(gdb) attach <PID>Important: After it is attached
to GDB, the MATLAB process will be suspended. You
must use the
continue command to have the process
resume running after the gdb prompt is returned:
(gdb) continueAt this point you are ready to start the Simulink® simulation, and begin debugging your design.