The Program section of the ECO Navigator, shown in the figure below, provides access to the commands that allow you to save your modifications, generate a new BIT file for programming and a new LTX file for your debug probes, and program the device.
Figure 1. ECO Navigator Program
Commands
- Save Checkpoint As
- This command allows you to save your modifications to a new checkpoint.Figure 2. Save Checkpoint As Dialog Box
- Generate Bitstream
- This command allows you to generate a new .bit file for programming.Figure 3. Generate Bitstream Dialog Box
- Write Debug Probes
- This command allows you to generate a new .ltx file for your debug probes. If you made changes to your
debug probes using the Replace Debug
Probes command, you need to save the updated
information to a new debug probes file (LTX) to reflect the changes in the
Vivado Hardware Manager.Figure 4. Write Debug Probes Dialog Box
