The local toolbar contains the following commands:
- Search
- Opens the search bar to allow you to locate messages.
- Collapse All
- Collapses all messages. Note: You can also access this command through the Ctrl+- keyboard shortcut.
- Expand All
- Expands all messages. Note: You can also access this command through the Ctrl+= keyboard shortcut.
- Reset Runs
- Invokes the Reset Runs dialog box
to remove previous run results and to set the run status back to
Not Started for the selected
runs.
- Reset to Previous Step
- Resets the selected run to the preceding step. This allows you to step
backward through a run, make any needed changes, and then step forward to
complete the run.
- Launch Runs
- Invokes the Launch Runs dialog box
to launch the selected runs.
- Launch Next Step
- Launches the next step of the selected run. For implementation runs, the
available steps are
opt_design
,place_design
,route_design
,write_bitstream
. Synthesis only has one step,synth_design
. - Create Runs
- Invokes the Create New Runs wizard
to create and configure new synthesis or implementation runs. For more
information, see this link in the
Vivado
Design Suite User Guide: Synthesis (UG901) or this link in the
Vivado Design Suite User Guide:
Implementation (UG904)
.
- Show Percentage
- Shows utilization by percentage rather than by number.