The smart-mipi-app application is targeted to run with Single-MIPI(Leopard IMX274 MIPI) or Quad-MIPI(Avnet Multi-Camera MIPI) sensor as input source, and HDMI as output sink. The application supports 4 models - yolov3, refinedet, densebox, ssd.
Follow these steps to boot the board into Linux
Ensure all steps under the section Board Setup are verified. Make connections based on the input source and output sink selected.
Insert the prepared micro SD card into the Versal SD card slot (refer to the image in Board Setup)
Have the UART0 terminal emulator tab connected.
Turn ON power switch SW13.
On Versal UART0 terminal, you would see the Versal device booting from the micro SD card starting with the message “Xilinx Versal Platform Loader and Manager”
In about 60 seconds boot is complete and will stop at the Linux prompt root@xilinx-vck190-2021_1
For ES1 VCK190 board, please run command /etc/init.d/aie_workaround4es1.sh in linux shell, production VCK190 board can skip this step
Use command line options provided below to run the smart-mipi-app application