Address Apertures - 2021.1 English

Vivado Design Suite User Guide: Dynamic Function eXchange (UG909)

Document ID
Release Date
2021.1 English

Each BDC has an addressable space available for connecting masters and slaves. The DFX BDC boundary apertures can either be manually specified, or left onto IP integrator to automatically infer them.

Tip: In most cases, the Auto setting is advised.
  • If set as Auto: Apertures will be automatically inferred by looking at all the design sources in the BDC. If an RM has apertures specified manually on the boundary, these will be used to compute the BDC apertures for the container. If not, boundary assignments in the child will be used for calculations. This will occur regardless of whether a bottom-up or top-down approach is used.

    If your static design has already been implemented with certain auto-computed apertures, adding a new RM source to the BDC will cause IP integrator to re-compute those apertures. If the calculated apertures are different than the previously computed apertures, the static result will be marked out of date and will need to be re-implemented.

  • If set as Manual: Apertures (either manually specified or derived from address assignments in the child) in the child will be validated against the manually specified apertures. If they are not compatible, DRCs will be issued.

Any new RM created using Create Reconfigurable Module command for a BDC will inherit the BDC-specified apertures. This is more relevant to the top-down flow.

Save BD As has been enhanced to Freeze the boundary of the new BD, which copies apertures from the current BD (presumably the default RM source), along with rest of the boundary and freeze it. In bottom-up flows, it ensures that newly created RMs are always restricted to match the BDC boundary.

Figure 1. Viewing the Address Aperture for a BDC