Running a Simulation - 1.2 English

Versal ACAP Integrated 600G Interlaken with FEC Subsystem Product Guide (PG371)

Document ID
Release Date
1.2 English

For all ILKNF IP configurations except FEC-Only mode, simulations can be run as follows:

  1. In the Sources Window, right-click the example project file (XCI), and select Open IP Example Design. The Vivado IP integrator block design-based example project is created.
  2. In the Flow Navigator, under Simulation, right-click Simulation Setting. In the Setting window, set Target Simulator to any of the supported simulators.
  3. In Flow Navigator pane, under Simulation, click Run simulation and select Run Behavioral Simulation. After this option has run, compilation and elaboration phase can be observed throughout the activity in the Tcl Console, and in the Simulation tab of the Log window.
  4. In the Tcl Console, type the run all command and press Enter. This runs the complete simulation as per the test case provided in example design test bench.

After Simulation is complete, the results can be viewed in the Tcl Console.